poltcms.blogg.se

Opensprinkler setup wifi
Opensprinkler setup wifi








opensprinkler setup wifi

The default device key is opendoor, which you can change in Settings. Open a browser and type in the IP address, it should open OSBee’s homepage show below.

opensprinkler setup wifi

This IP address is printed on the LCD screen at the bottom. In WiFi station mode, OSBee obtains an IP address from your home WiFi router. If you want to change the WiFi network, you can perform a factory reset and it will go back to AP mode. From now on, it remembers your WiFi and will always attempt to connect to it when it’s powered on. At this point, OSBee will attempt to connect to your WiFi, and if successful, it will reboot itself, and now WiFi configuration is complete. If you have already created a Blynk app token (see Section 5), you can also paste it here, otherwise, just leave the token blank.

Opensprinkler setup wifi password#

So choose, or directly type in your home WiFi’s SSID and WiFi password (Note: it only connects to 2.4G WiFi). The main purpose of the WiFi configuration is to let OSBee know your home WiFi’s name and password, so that it can subsequently connect to your WiFi. This should open the WiFi configuration page. Once connected, open a web browser on your phone (or laptop) and type in the IP address 192.168.4.1. Use your smartphone, or laptop to connect to this WiFi SSID (there is no WiFi password). In this mode, OSBee creates a WiFi SSID, the name of which is printed on the LCD screen (e.g. The first time you power on OSBee, or after each factory reset, the controller starts in AP (Access Point) mode. OSBee is powered by a USB adapter through a microUSB cable.

opensprinkler setup wifi

Un-tighten a screw, insert the wire through the opening below it, wrap the wire around the screw, then tighten the screw. At the back of the controller there are four big screws. The positive (+) wire (often colored red) of each valve should be connected together and go to the COM terminal the negative (-) wire (often colored black) of each valve should go to an individual zone (1, 2, or 3). OSBee has four terminals marked COM (common), Z1 (zone 1), Z2, and Z3.










Opensprinkler setup wifi